Installing The Compact Flash Memory Card - Cisco 3600 Series Installation Manual

Chapter 5 Installing Memory in the Router
Figure 34
Remove the retention screw that retains the Compact Flash memory card by using the Phillips
Step 2
screwdriver; save the retention screw for reinstallation.
Carefully pull the Compact Flash memory card free from the connector.
Step 3
Place the removed Compact Flash memory card on an antistatic surface or in a static shielding bag.
Step 4

Installing the Compact Flash Memory Card

You can install a Compact Flash memory card with 32-, 64-, or 128-MB of memory.
Perform the following steps to install the Compact Flash memory card:
Locate the Compact Flash memory-card connector on the CPU/mainboard. (See
Step 1
Insert the connector end of the Compact Flash memory card into the connector until the card is seated
Step 2
in the connector. The card is keyed, so that it cannot be inserted wrong.
Step 3 Reinstall the retention screw to retain the Compact Flash memory card.
Install the chassis cover as described in the
Step 4
section on page
Step 5 Refer to the
instructions on formatting the Compact Flash memory card.
OL-2056-02
Compact Flash Memory Card Location in a Cisco 3631
Compact Flash
memory card
Retention screw
5-30.
"Formatting Procedures for Compact Flash Memory Cards" section on page 5-49
Installing and Formatting Compact Flash Memory Cards in Cisco 3631 Routers
"Replacing the Cover on a Cisco 3620 or Cisco 3640 Router"
Cisco 3600 Series Hardware Installation Guide
Figure 34.)
for
5-47