Table of Contents
Advertisement
Troubleshooting
Trouble
Sander will not start.
Abrasive belt won't
track properly.
Abrasive disc comes
free of aluminum
disc.
Abrasive belt slips or
stalls on application
of pressure.
Aluminum disc stalls.
Excessive abrasive
belt replacement.
Belt arm won't index.
Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call
1-800-274-6848, Monday through Friday (see our website for business hours, www.powermatic.com).
Having the Model Number and Serial Number of your machine available when you call will allow us to
serve you quickly and accurately.
Probable Cause
Disconnected from power source.
Incorrect voltage.
Switch is not activating.
Motor is faulty.
Platen is shifted or worn.
Belt is stretched unevenly.
Drum is worn.
Improper bond.
Abrasive belt tension is inadequate.
Excessive pressure.
Drive belt is loose.
Drive belt is loose.
Disc shaft key is missing.
Using too much pressure when
sanding.
Not using full width of belt.
Index pin is stuck.
Broken spring.
Remedy
Check connection to source.
Make sure power source matches
voltage of sander, as shown on motor
name plate.
Repair or replace switch.
Repair or replace motor.
Raise platen to 1/32" beyond the apex
of the drum. See page 14.
Replace belt.
Replace drum.
Clean adhesive off aluminum disc,
then re-apply adhesive and re-mount
abrasive disc.
Tighten abrasive belt (page 10).
Reduce pressure against belt.
Properly tension drive belt (page 9).
Properly tension drive belt (page 9).
Replace key.
Reduce pressure against belt.
Stroke across full width of belt to
disperse wear.
Remove arm and free index pin.
Remove arm and replace spring.
20
Advertisement
Table of Contents
