Figure 123 : Tk 6000/7000 Pcb And Cable; Figure 124 : Tk 2300 And Adapter - AVE VSI-Pro Max Operation Manual

ECR / TPIF INTERFACE CARDS
The ECR Interfaces are small PCBs that mount internally to the cash registers. These PCBs convert internal data
from matrix and drum printers or thermal printers to RS-232 data. This RS-232 data is then connected directly to the
VSI-Pro for display. It also can be connected directly to the Regcom to send up to 16 cash register's data on a central
collection PC or DVR.
The ECR Interfaces have many different connection types depending on the make and model of cash register.
Typically the RS-232 cable comes from the rear of the register to further connect to the VSI- Pro or DVR. The
manufacturer and model number of the cash register must be supplied when ordering this ECR Interface.
Figure 123: TK6000/7000 PCB and Cable
When using the AVE IF ECR Interface PCBs that are generally installed inside the cash register and an RS-232
connector mounted on the register or the RS-232 cable fitted through the rear of the till. These interfaces output
direct converted and formatted RS-232 of the printer. This data can be connected directly to the AVE line of DVRs
without additional conversion up to 100'. If additional lengths are needed then the AVE RS-232 to RS-422/485
converter can be used to extend this range to 3000'.
The Regcom interface can directly connect to these devices and report up to 16 tills on the Regcom network back to
the PC Program or to the AVE line of DVRs converted using the Hydra.
ANSI DRIVER COMMANDS
SET CURSOR
<ESC>[Y;XH ->
CLEAR DISPLAY
<ESC>[2J
REVERSE TEXT
<ESC>[7M
FLASH TEXT
<ESC>[5M
NORMAL TEXT
<ESC>[0M
** <ESC> = 1BH
** Pn = The distance moved is determined by this parameter. If the parameter value is not set then default value will
be 1
VSI-Pro Max POS / Cash Register Interface
Figure 124: TK2300 and Adapter
Y is vertical, X is horizontal , X and Y set by numeric character (0-9)
Ex. Vertical line = 5 , Parameter Y will be set to "35H"
Horizontal line = 19 , Parameter X will be set to "31H39H"
Result Hex format = 1BH 5BH 35H 3BH 31H 39H 48H
Table:4 ANSI Driver Commands
CLEAR CURRENT CURSOR TO END OF LINE
<ESC>[K
CURSOR DOWN
<ESC>[PnB
CURSOR UP
<ESC>[PnA
CURSOR LEFT
<ESC>[PnC
CURSOR RIGHT
<ESC>[PnD
68
APPENDIX H
Figure 125: TE2200 Thermal
Printer
APPENDIX I