Connections; Led Indicators - AVE VSI-Pro Max Operation Manual

Pos / cash register interface

Hide thumbs Also See for VSI-Pro Max:

Table of Contents

3. CONNECTIONS

The VSI-Pro Max will overlay the characters on any input video source. The video input can be virtually any baseband

or composite video source. The VSI-Pro will accept NTSC, RS-170, RS-330, CCIR, PAL or SECAM video formats.The

Video input to the VSI-Pro Max is a standard BNC connector, terminated at 75 [ohms].

NOTE

The input video level must be between 0.5V - 2.0V Peak to Peak. If the video is lower or not

present the VL LED will illuminate signifying low or no video and the VSI-Pro Max will have a

poor or no output video signal.

After completing the interface installation as described in the separate Installation Guide for your specific cash

rear of the VSI-Pro Max. The BNC video output goes out to the video system (VCR, DVR, quad, switcher, multiplexer,

or monitor). This connection is shown in Figure 4. The video output from the VSI-Pro Max is 1[V] Peak to Peak into

a 75 [ohm] load. Most monitors or televisions with direct video inputs are terminated with a 75 ohm load. If the

monitor is not terminated, the VSI-Pro Max will still output 1[V] Peak to Peak. The VSI-Pro Max will be able to drive

two terminated loads without loss of video level.

The VSI-Pro Max uses a 9-12VDC @300 [mA] UL/CSA power supply which must be plugged into the Power input on

the VSI-Pro Max's Real Panel.

Power

Green Signifies power is supplied to the unit

Network LED

Red

Video Error

Red

Figure 2: VSI-Pro Max RJ45 Network Connections

VSI-Pro Max POS / Cash Register Interface

received from the cash register

This LED flashes whenever data is

sent or received on the Network Port

This LED illuminates with the video

level is not present or too low

Figure 1: VSI-Pro Max Front Indicator LEDs and

Programming Pushbuttons

Figure 3: VSI-Pro Max Rear Connections

Table of Contents