Stanley Erin Installation And Operating Instructions Manual page 7

(B). Open the fire door using the detachable han
dle and remove the contents from the fire
box.
Fig.3
(C). Remove the hob and place to one side, tak
ing care not to damage the enamel finish.
(D). Lay the stove on its back taking care not to
damage rear of stove.
(E). Fit the ashtray to the base using the two
1 /2
x " long round head screws and two of the
3 /8
" washers provided. Fit the tool holder to
the base using the two
tersunk screws, and two of the 3/8" washers
provided (See Fig.4).
Fig.4
(F). Fit the secondary air control rod bracket to
the ashtray using the two
round head screws and the two lock washers
provided. Fit the connecting rod through the
control rod bracket with the notches facing
downwards and leave it hanging loose until
the stove is standing upright. (See Fig.5).
1 /4
"
1 /4 1 /2
" x 1 " long coun
1 /4 1 /2
" x " long
Fig.5
(G). Remove the four M10 bolts from the base,
and fit the four legs using the four M10 x
20mm long bolts and the 3/8" washers pro
vided in the jiffy bag. (See Fig.6).
Fig.6
(H). Stand the stove upright, taking care not to
strain the back leg bolts. Attach the sec
ondary air damper assembly to the back
panel using the two
head screws and the two lock washers pro
vided (See Fig.7). Connect the connecting
rod to the secondary air damper assembly
and fix it into place using the split pin and
1 /4
" washer provided in the jiffy bag. Ensure
that the ends of the split pin are bent back
1 /4
with the
the ends of the split pin.
Fig.7
Secondary Air
Damper Assembly
7
1 3
" x " long round
/4 /4
" washer between the casting and