Floor Protection; Stove Dimensions; Commissioning & Handover; Operation - Stanley Erin Installation And Operating Instructions Manual

FLOOR PROTECTION

When installing this heater on a combustible floor, a
floor protector, consisting of a layer of non com-
bustible material at least
(6mm) thick covered with
is required to cover the area under the heater and to
extend to at least 18" (460mm) at the front and 8"
(200mm) to the sides, and rear, this will provide pro-
tection from sparks and embers which may fall out
from the door when stoking or fuelling, See Fig. 13
Fig.13
127mm
127mm
460mm

STOVE DIMENSIONS

Fig.14
3
" (10mm) thick or
/8
1
" (3mm) sheet metal. It
/8
127mm
Fig.15
1
"
/4
WARNING:
AIR SUPPLY TO THE STOVE
Note: Dimensions stated are in millimetres and
may be subject to a slight +/- variation.
COMMISSIONING AND HANDOVER
On completion of the installation allow a suitable
period of time for any fire cement and mortar to dry
out, when a small fire may be lit and checked to
ensure the smoke and fumes are taken from the
stove up the chimney and emitted safely to the
atmosphere. Do not run at full output for at least
24 hours.
Ensure that the operating instructions for the stove
are left with the customer. Ensure to advise the cus-
tomer on the correct use of the appliance with the
fuels likely to be used on the stove and warn them to
use only the recommended fuels for the stove.
Advise the user what to do should smoke or fumes
be emitted from the stove. The customer should be
warned to use a fireguard to BS 8432:2010 in the
presence of children, aged and/or infirm persons.

OPERATION

Check that all dampers and catches are operating
correctly and ensure that all flue connections are
thoroughly sealed.
11
DO NOT OBSTRUCT PRIMARY