Operation; Overview; Display Modes; Authentication Device - Honeywell XYR 6000 User Manual

5. Operation

5.1. Overview

5.1 Overview

Display modes

The transmitter has the following display modes.

Test. Appears briefly after power-up to self-test the display.

Connection status. Appears when transmitter is not fully connected to the OneWireless network. See
section 5.2.

PV display. Default mode of the transmitter displays the PV and any status messages. See section 5.3
on page 16.

Quick view of transmitter identification parameters. Displays read-only parameters then returns to PV
display. See section 5.4 on page 20.

Menu. See section 5.5 on page 21.

Authentication Device

To navigate the transmitter displays and menus, hold the Authentication Device no more than 6" from the
transmitter and aim the infrared beam at the transmitter display while tapping the Device Local
Configuration buttons (Table 7).
Authentication Device menus are described in section 5.6 starting on page 22.
14
5. Operation
OneWireless XYR 6000 Pressure Transmitter R120 User's Manual Revision 8

November 2010