Skoda Rapid Owner's Manual page 25

The multifunction display can only be operated when the ignition is switched on.
After the ignition is switched on, the function that was last selected before
switching off the ignition is displayed.
For vehicles with a MAXI DOT display, the menu item MFA must be selected and
confirmed in the main menu » page
On vehicles with a MAXI DOT display, there is an option to fade out some of the
information » page 26, Settings.
WARNING
Concentrate fully at all times on your driving! As the driver, you are fully re-
■
sponsible for the operation of your vehicle.
Even at temperatures of around +4 °C, black ice may still be on the road sur-
■
face! You should therefore not only rely on the outside temperature display
for accurate information as to whether there is ice on the road.
Note
In certain national versions the displays appear in the Imperial system of meas-
■
ures.
If the display of the second speed is activated in mph, the current speed is not
■
indicated in km/h on the display.
The amount of fuel consumed will not be indicated.
■
Memory
Fig. 9
Multi-function display - Display example of the memory
25, MAXI DOT display.

First read and observe the introductory information and safety warn-
ings on page 22.
The multifunction display is equipped with two automatic memories, 1 and 2. The
selected memory is shown in the Display
Single-trip memory (memory 1)
The single-trip memory collates the driving information from the moment the ig-
nition is switched on until it is switched off. New data will also flow into the cal-
culation of the current driving information if the trip is continued within 2 hours
after switching off the ignition. If the trip is interrupted for more than 2 hours,
the memory is automatically erased.
Total-trip memory (memory 2)
The total trip memory collates the data from any number of individual trips up to
a total of 19 hours and 59 minutes or a 1999 km distance or, for vehicles with a
MAXI DOT display, 99 hours and 59 minutes, or a 9999 km distance. The memory
is deleted when either of these limits is reached and the calculation starts all over
again.
Unlike the single-trip memory, the total-trip memory is not deleted after a period
of interruption of driving of 2 hours.
Select memory
›
Select the corresponding element of the multi-function display
the information system.

›
Press button or the adjustment wheel
B
Reseting
›
Select the corresponding element of the multi-function display
the information system.
›
Select the desired memory.
›
Press and hold button or adjustment wheel
B
The following values of the selected memory are set to zero.
›
Average fuel consumption.
›
Distance driven.
›
Average speed.
›
Driving time
Note
All information in the memory 1 and 2 is erased if the battery of the vehicle is dis-
connected.
» Fig. 9.
» page 20, Using
» Fig. 7 on page 20 briefly.
D
» page 20, Using
» Fig. 7 on page 20.
D
Information system

23