CAUTION
Do not take hold of the glass bulb with naked fingers (even the smallest
■
amount of dirt reduces the working life of the light bulb). Use a clean cloth, nap-
kin, or similar.
When removing and installing the number plate light and tail light make sure
■
that the paintwork of the vehicle and the tail light are not damaged.
Note
This Owner's Manual only describes the replacement of bulbs where it is possi-
■
ble to replace the bulbs on your own without any complications arising. Other
bulbs must be replaced by a specialist garage.
We recommend that a box of replacement bulbs always be carried in the vehi-
■
cle. Replacement bulbs can be purchased from ŠKODAOriginal Accessories.
We recommend having the headlight settings checked by a specialist garage af-
■
ter replacing a bulb in the main, low or fog beam.
In case of failure of a xenon gas discharge lamp or an LED diode, visit a special-
■
ist garage.
Bulb arrangement in the headlights
Fig. 168 Principle sketch: Headlight with halogen bulb/with Xenon bulb
194
Do-it-yourself
First read and observe the introductory information and safety warn-
ings
on page 193.
Headlight with halogen bulb
Low beam
1
Main beam, separate daytime running lights, and parking light
2
Turn signal light (at the front)
3
Headlights with Xenon light
Low beam with Xenon light
4
Main beam, separate daytime running lights, and parking light
5
Turn signal light (at the front)
6
Replacing the low beam bulb
First read and observe the introductory information and safety warn-
ings
on page 193.
›
Remove the rubber cover
1
›
Remove the connector with the bulb by pulling it back in the direction of the ar-
row with loosening movements
›
Remove the connector.
›
Insert a new light bulb in such a way that the fixing lugs of the bulb fit in the
recesses of the reflector.
›
Fit the connector.
›
Insert the rubber cover
» Fig. 168
1
Fig. 169
Headlight with halogen bulb:
Bulb for low beam
» Fig. 168
on page 194.
» Fig.
169.
on page 194.