Inner part of the light
›
Unlock the bulb holder using the locking latches marked with arrows
and remove the holder from the tail lamp.
›
Turn the bulb holder
» Fig. 177
- anti-clockwise to the stop and remove it
from the lamp housing.
›
Replace the bulb, insert the holder with the bulb into the lamp housing and turn
in a clockwise direction to the stop.
›
Insert the bulb holder in the tail lamp assembly.
All locking mechanisms must audibly snap into place.
Rear light (Rapid Spaceback)
Fig. 178 Remove cover/light
Fig. 179 Installing the lamp connector/lamp
198
Do-it-yourself
First read and observe the introductory information and safety warn-
» Fig. 177
-
ings
on page 193.
Removing
›
Open the boot lid.
›
Insert the clamp for removing the wheel trims
the hole at the position indicated by the arrow
›
Remove the cover in the direction of the arrow
›
Use the screwdriver from the tool kit
›
Grip the rear lamp assembly and carefully remove it by waggling it and pulling
opposite the direction of travel.
›
Carefully remove the plug from the rear light
Installing
›
Insert the connector into the lamp and lock it securely.
›
Insert the light into the brackets in the body
›
Carefully press the tail lamp assembly into the bodywork so that the bolts
» Fig. 180
on page 199 on the light latch with the mounts in the body
2
Be careful not to pinch the cable bundle between the bodywork and light.
›
Screw the tail lamp into place and install the cover.
The cover must engage firmly.
CAUTION
Ensure that the cable bundle is not pinched between the bodywork and the
■
light as it is refitted – there is a risk of damage to the electric installation and wa-
ter ingress.
If you are not sure whether the cable bundle has been pinched, we recommend
■
that you have the connection of the light checked by a specialist garage.
» page
176, Vehicle tool kit into
» Fig. 178
- .
» Fig. 178
- .
» Fig. 178
- to unscrew the lamp.
» Fig. 179
- .
» Fig. 179
- .
»
.