Sharp MX-B382 Technical Handy Manual page 9

SHARP
PRINT IMAGE POSITION & MAGNIFICATION
Automatic Adjustment:-
Sim 50-28
Manual Adjustment:-
Sim 50-10
Sim 50-10
Sim 50-05
ENGINE & PRINTER HALF TONE CALIBRATION
Sim 46-74
COPY IMAGE QUALITY
Check Image Quality (Copy Mode) – Density, Magnification, Lead Edge & Void.
If NG, perform the following adjustments as required:-
Manual Adjustment (Magnification, Lead Edge, Void, Off Centre etc).:
PRINT IMAGE QUALITY
Check Image Quality (Print Mode) – Density.
Sim 64-05
Sim 64-06
PERIPHERAL / OPTION CONFIGURATION
FINISHER – MX-FN12
Sim 26-65
BK MAG ADJ (Main Scan Mag).
SETUP/PRINT ADJ (Lead, Offset or All).
BK MAG (inside dimension) to 240mm.
Image Off Centre Adjustment.
Printer Lead Edge & Void Adjust.
Engine & Printer Calibration:-
Sim 46-02 Copy Density Adjust. (B/W).
Sim 46-09 SPF Copy Density Adjust.
Sim 50-28 OC ADJUST (Lead, Offset & Mag).
SPF ADJ:(Lead, Offset & Sub scan).
Sim 48-01 Magnification Adjustment (OC & SPF).
Sim 50-01 Lead/Rear Edge, Loss & Void Adjust.
Sim 50-12 OC & SPF Off Centre Adjust.
PCL Density Test Page.
PS Density Test Page.
Finisher Alarm Mode:-
Limit number of Copies in staple mode (ON/OFF).
MX-B382 INITIAL SETUP
Select FACTORY Mode.
9