Sharp MX-B382 Technical Handy Manual page 35

SHARP
24
Data Counter & Clear
7 Drum correction counter clear
9 Print & other counter clear
10 Fax counter clear [MX-B382]
15 Network scan counter clear [MX-B382]
25 Toner usage estimator counter clear
30 Administrator password initialisation
31 Service password initialisation
34 Initialise Sim 26-32 settings
25
DV Auto Adjustment & Monitor
1 Toner sensor monitor (Process drive)
2 Auto developer adjustment setting
26
Device Configuration
2 LCC size set-up
3 Auditor setup [MX-B382]
6 Destination set-up
10 Network scanner trial mode [MX-B382]
18 Toner save operation
30 CE mark control setup
32 System setting menu display setting
35 Trouble memory mode setting
38 Engine life over setting (Developer)
41 Pamphlet mode AMS operation [MX-
B382]
49 Copy mode setup (Postcard) [MX-B382]
50 Function setting
52 Blank paper count mode setting
53 Enable/Disable auto calibration [MX-
B382]
54 Enable/Disable auto calibration for printer
65 Finisher alarm mode set-up
69 Toner near end setting
73 Poster enlargement adjustment [MX-
B382]
74 OSA Trial Mode setting
78 Remote panel operation password setting
30
Sensor Operation & Test
1 Main unit sensor check
2 Tray sensor check (main)
40
Bypass Operation & Adjustment
2 Bypass tray width adjustment
7 Bypass tray width detection manual
setting
TEST SIMULATION
41
OSS Adjustment
1 Document sensor operation check
2 Document sensor output setup
3 Document sensor output display
43
Fuser Setting & Adjustment
1 Fuser temperature setup (Paper)
4 Fuser temperature. setup for each mode
20 Fuser correction for low temp/humidity
21 Fuser correction for high temp/humidity
22 L/L correction for fuser temperature
setting
23 H/H correction for fuser temp. setting
24 Fuser temperature reset
44
Process Control Data
1 Process control mode setting
2 Process control Gain Adjustment
4 Process control initial density setup
6 Process control correction (force)
9 Process control data display
12 DM data, patch/base data display
14 Temp.& humidity output data
16 Toner control output data display
21 Half tone process control registration
22 Half tone process control patch result
24 Half tone correction data result display
25 Initial half tone correction data display
26 Half tone process control correct
execution
27 Half tone process control correction clear
28 Process control timing (On/Off) setting
29 Enable/disable half tone correction (job)
37 Image density (DVB) adjust setting
43 DV unit installation monitor
46
Image Density Adjustment
2 B/W copy density adjustment [MX-B382]
4 Colour scanner density adjustment.
5 B/W scanner density adjustment.
8 Colour scanner balance adjustment.
9 SPF exposure adjustment.
16 Engine balance manual adjustment B/W.
19 B/W auto exposure mode setup.
21 Engine density balance adjustment
23 Engine maximum density adjustment.
24 Engine half tone auto adjustment.
32 Document background density adjustment
[MX-B382]
[MX-B382]
35