Sharp MX-B382 Technical Handy Manual page 36

TEST SIMULATION
46
Image Density Adjustment
37 B/W image create adjustment.
39 Fax Image send sharpness adjustment.
40 Fax mode exposure adjust (All modes).
41 Fax mode exposure adjust (Normal).
42 Fax mode exposure adjust (Fine Text).
43 Fax mode exposure adjust (Super Fine).
44 Fax mode exposure adjust (Ultra Fine).
45 Fax mode exposure adjustment (600dpi).
47 JPEG compression rate setting.
51 Heavy paper mode gamma adjustment.
60 Sharpness adjustment (colour auto mode).
61 Area separation recognition setting.
62 ACS operating condition setting.
63 Copy low density adjustment.
74 Copy colour balance adjustment.
48
Magnification & Motor Adjustment
1 Magnification ratio adjustment [MX-
B382]
5 Motor speed adjustment (Scanner & SPF)
[MX-B382]
6 Motor velocity adjustment
49
Firmware & E-Manual Upgrade
1 Firmware Upgrade Program
3 E Manual Update Program
50
Image Position Adjustment
1 Lead edge/copy position adjustment
2 Lead edge/copy position adjustment value
calculation [MX-B382]
5 Printer lead edge adjustment (sub scan)
6 SPF Lead edge/copy position adjustment
[MX-B382]
7 SPF Lead edge/copy adjustment value
[MX-B382]
10 Print off-centre deviation adjustment.
12 Original centre deviation adjustment.
[MX-B382]
27 Image loss adjustment (Fax/Scanner)
28 Service adjustment (OC/SPF position)
51
Resist Roller Adjustment
2 Resist roller adjustment
53
SPF Adjustment
8 SPF scanning position adjustment
36
[MX-B382]
[MX-B382]
55
MFP Data Setting
1 Engine soft switch setting
2 Scanner soft switch setting
3 Controller soft switch setting:-
SW1-5 Auto clear function before copy
job execution [MX-B382]:-
0 =Disabled, 1 = Enabled
SW3-6 Process mixed original size
printing for duplex mode:-
0 =Disabled, 1 = Enabled
SW3-7 HP Compatibility Mode:-
0 =Disabled, 1 = Enabled
SW5-1 Setting of HID Card Reader
SW5-2 support
SW5-3 (enable bits 1, 2 & 3)
0 =Disabled, 1 = Enabled
SW6-1 Ethernet Speed Auto
negotiation:-
0 = Enabled, 1 = Disabled
SW6-2 Ethernet Link Speed:-
0 = 100Base TX, 1 = 10Base T
SW6-3 Ethernet Duplex Mode:-
0 = Full, 1 = Half
SW6-4 Ethernet 100/1000 Link Speed:-
0 = 100Base TX, 1 = 1000Base T
SW9-5 Maintenance notification
setting by Printer MIB:-
0 = Enabled, 1 = Disabled
SW22-5 Display toner remaining
(Status):-
0= Disabled, 1 = Enabled/Display
SW22-7 LCD character display font
[MX-B382]:-
0 = Standard, 1 = Bold
SW24-7 Continuous print mode for OSA
(job queuing for external
accounting):-
0 = Job Queue Disabled
1 = Job Queue Enabled
56
MFP Data Import & Export
1 Transfer data execute
2 Export/Import Filing Data
3 Document filing data backup
4 Job log data backup
SHARP