Cisco aironet 1522 Design And Deployment Manual page 89

Using the CLI to Enable 1522 and 1524PS Association with Cisco 3200
To enable an AP1522 or AP1524PS to associate with Cisco 3200, follow these steps.
To enable client access mode on the AP1522 and AP1524, enter this command:
Step 1
config mesh client-access enable
To enable the public safety on a global basis, enter this command:
Step 2
config mesh public-safety enable all
To enable the public safety channels, enter these commands:
Step 3
a.
b.
To save your changes, enter this command:
Step 4
save config
To verify your configuration, enter these commands:
Step 5
show mesh public-safety
show mesh client-access
show ap config 802.11a summary (1522 only)
show ap config 802.11–a49 summary (1524PS only)
Note
Configuring Power and Channel Settings
The backhaul channel (802.11a/n) can be configured on a RAP. MAPs tune to the RAP channel. The
local access can be configured independently for MAPs.
Cisco Aironet 1520, 1130, 1240 Series Wireless Mesh Access Points, Design and Deployment Guide, Release 6.0
OL-20213-01
On the AP1522, enter these commands:
config 802.11a disable Cisco_MAP
config 802.11a channel ap Cisco_MAP channel number
config 802.11a enable Cisco_MAP
On the AP1524PS, enter these commands:
config 802.11–a49 disable Cisco_MAP
config 802.11–a49 channel ap Cisco_MAP channel number
config 802.11–a49 enable Cisco_MAP
Enter config 802.11–a58 enable Cisco_MAP to enable a 5.8-GHz radio.
Note
For both the AP1522 and AP1524PS, channel number is equal to any value 1 to 26.
Note
Enter show config 802.11-a58 summary to display configuration details for a 5.8-GHz radio.
Connecting the Cisco 1520 Series Mesh Access Point to Your Network
89