Data Transfer Rate - Panasonic CF-T2 Series Reference Manual

SD Memory Card/MultiMedia Card
Do not take the SD memory card apart or try to modify it.
Do not hit, bend, or drop the card, or allow it to get wet.
Do not touch the metal terminals with your hands or with metal.
Do not remove the labels on the card.
Do not attach other labels or seals to the card.
Do not leave the card in locations that can become very hot, such as inside a car that can
become hot or in direct sunlight.
Do not leave the card in dusty locations or locations that are very humid.
Do not leave the car in locations subject to corrosive gas, etc.
When resuming from standby or hibernation mode
After resuming from standby or hibernation mode, do not access the SD memory card for
about 30 seconds.
Protecting important data
Set the write-protect switch (A) to the LOCK position. Unlock the switch when you want to
record (checkout), edit, or save data.
Use an oil-base felt-tip pen to write in the memo area (B) on the card. Do not use a pencil
or ball-point pen. Doing so can damage the card body or destroy data stored in the card.
Do not remove the card or turn off the device while data is being read from or written to
the card, or for a short time after the writing operation, while the SD memory card
indicator ( page 54) is lit. Doing so can destroy data stored in the card. (Note that
Panasonic assumes absolutely no liability for any loss of data recorded by the user, or
any other damages, direct or indirect.)
We recommend backing up important data to another storage medium.

Data transfer rate

The transfer rate using the SD memory card slot on this computer is 2MB per second. The
transfer rate is 2MB per second even if you use an SD memory card that supports high-
speed transfer rates.
52