Fcc, Acta And Ic Regulations - VTech LS6125 User Manual

FCC, ACTA and IC regulations

FCC Part 15
This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal
Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
C hang es or m od i cations to this eq u ipm ent not ex pressly approv ed b y the party responsib le for com pliance cou ld v oid the u ser's au thority to
operate the equipment.
This device complies with Part 15 of the FCC rules. O peration is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Privacy
of communications may not be ensured when using this telephone.
To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be safely absorbed by a user or
bystander according to the intended usage of the product. This product has been tested and found to comply with the FCC criteria. The handset
may be safely held against the ear of the user. The telephone base shall be installed and used such that parts of the user's body other than
the hands are maintained at a distance of approximately 20 cm (8 inches) or more. If you choose to use a clipping device, please make sure to
only use the supplied VTech belt clip.
This Class B digital apparatus complies with Canadian ICES-003.
FCC Part 68 and ACTA
This equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the Administrative Council for Terminal
A ttachm ents (A C TA ). The lab el on the b ack or b ottom of this eq u ipm ent contains, am ong other thing s, a prod u ct id enti er in the form at U S :
A A A E Q # # TX X X X . This id enti er m u st b e prov id ed to y ou r local telephone com pany u pon req u est.
The plug and jack used to connect this equipment to premises wiring and the telephone network must comply with applicable Part 68 rules
and technical requirements adopted by ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be
connected to a compatible modular jack that is also compliant. An RJ11 jack should normally be used for connecting to a single line and an
w w w .v tech ph ones.com
45