T roub lesh ooting
Problem
Suggestion
The answering system
•
Make sure the answering system is on. When the answering system is on, the red light on the
A N S O N /O FF key should be lit.
does not answer after
the number of rings
•
If Toll Saver is selected, the number of rings changes to two when there are new messages
which I programmed it.
waiting (page 29).
•
If the memory is full or if the answering system is off, the system will answer after ten rings.
•
In some cases, the answering system will be affected by the ringing system used by the local
telephone company.
The outgoing
•
When recording the announcement, make sure you speak in a normal tone of voice about nine
announcement is not
inches from the telephone base.
clear.
•
M ak e su re there is no b ack g rou nd noise (telev ision, m u sic, traf c, etc.) w hen record ing .
Press V O L
The messages on the
•
sy stem are v ery d if cu lt
to hear.
The answering system
•
Make sure the answering system is on.
does not record
•
If the answering machine memory is full, it will not record new messages until some old
messages.
messages are deleted.
The messages on the
•
If a caller leaves a very long message, part of it may be lost when the system disconnects the
answering system are
call after four minutes.
incomplete.
•
If the memory on the system becomes full during a message, the system stops recording and
disconnects the call.
•
If the caller's voice is very soft, the system may stop recording and disconnect the call.
52
on the telephone base to increase the speaker volume.
w w w .v tech ph ones.com