Consumable Parts - Panasonic WV-S6131 Important Information Manual

Consumable parts

The following are consumables: Replace them
in accordance with their operating lifetimes.
Their operating lifetimes vary depending on the
usage environment and conditions. The oper-
ating lifetimes below are just guides for when
using the camera at +35 °C {95 °F}.
S6131
S6111
• Lens unit, panning motor, tilting motor, flat
cable for tilting, slip ring: Approx. 3.7 mil-
lion operations (Approx. 20000 hours)
* When continuing the action of moving the set
position for a long period, dust may accumulate
on a slip ring. It can be prevented by executing
the position refresh action regularly (about once
a week) using the schedule setting.
S6130
• Lens unit, panning motor, tilting motor, flat
cable for panning, flat cable for tilting:
Approx. 3.7 million operations (Approx.
20000 hours)
Do not hold the dome section.
The dome section of this unit rotates. When
removing this unit from a ceiling or wall, turn
the unit while holding the fixed section.
Motor operating sound
The operating sound may be louder depending
on the speed of panning/tilting operations.
When you feel uneasy, the operating sound
can be diminished by reducing the setting
value of auto panning speed.
AVC Patent Portfolio License
THIS PRODUCT IS LICENSED UNDER THE AVC
PATENT PORTFOLIO LICENSE FOR THE PER-
SONAL USE OF A CONSUMER OR OTHER USES
IN WHICH IT DOES NOT RECEIVE REMUNERA-
TION TO (i) ENCODE VIDEO IN COMPLIANCE WITH
THE AVC STANDARD ("AVC VIDEO") AND/OR (ii)
DECODE AVC VIDEO THAT WAS ENCODED BY A
CONSUMER ENGAGED IN A PERSONAL ACTIVITY
AND/OR WAS OBTAINED FROM A VIDEO PRO-
VIDER LICENSED TO PROVIDE AVC VIDEO. NO
LICENSE IS GRANTED OR SHALL BE IMPLIED
FOR ANY OTHER USE. ADDITIONAL INFORMA-
TION MAY BE OBTAINED FROM MPEG LA, L.L.C.
SEE HTTP://WWW.MPEGLA.COM
Lens and pan/tilt head
If a lens and pan/tilt head are not performed for
a long period of time, the grease coating inside
these parts may become sticky. That may
obstruct the parts from moving. To prevent
this, move the lens or pan/tilt head periodically.
Or perform position refresh.
Position refresh
During the use for a long period of time, the pre-
set positions may become inaccurate. When
"Position refresh" is set for the created schedule,
the camera position will be corrected periodically.
Refer to the Operating Instructions on the provid-
ed CD-ROM for how to perform the settings.
Equipment classification and power
source indication label
Refer to the indication label on the bottom side
of this unit for the equipment classification,
power source, and other information.
Product disposal/transfer
Data saved on this product or a storage device
used with this product may lead to personal
information leakage. When it is necessary to
dispose or give this product to someone, even
when for repair, make sure that there is no data
on this product.
When abandoning the memory media, it is rec-
ommended to destroy it physically after delet-
ing data by PC.
Meaning of symbols
: Direct current symbol
S6130
: Hot surface symbol
12