Table of Contents
Advertisement
Operating Instructions
Parts and their functions
Camera unit
5
8
Rear panel
9
10
LAN
LINK
ACT
RS-422
12 V
IN
IR ID
AUDIO IN
15
16
18
17
Bottom panel
6
20
46
1
2
3
4
5
6
7
11
12
13
14
SERVICE
3G SDI OUT
G/L IN
19
1.
Mount bracket for installation surface (supplied
accessory)
Mount this bracket onto the installation surface, and then attach the
camera main unit to the bracket.
2.
Drop-prevention wire
This wire is screwed down to the bottom panel of the camera main
unit. Loop the circle part of the wire around the hook of the mount
bracket.
3.
Status display lamp
This lights in the following way depending on the status of the unit.
Orange
Light up
When the standby status is established
Blink twice
When a signal not matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
Green
Light up
When the power is on
Blink twice
When a signal matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
Blinking
When the initialization process is complete
rapidly
Red
Light up
When trouble has occurred in the unit
Blinking
Firmware being updated
slowly
Blinking
When a PoE++ software authentication error has
rapidly
occurred
4.
Pan head
This rotates in the right and left direction.
5.
Wireless remote control signal light-sensing area
The light-sensing area is provided in three places, on the front panel
of the camera pedestal and at the top of the rear panel.
6.
Hole for securing the camera pedestal
This hole is provided in the bottom panel of the camera pedestal.
7.
Camera head
This rotates in the up and down direction.
8.
Tally lamp
This comes on or goes off in response to the control from the
controller but only when "On" has been selected as the tally lamp use
setting. The tally lamp is red or green.
9.
LAN connector for IP control <LAN LINK/ACT>
This LAN connector (RJ-45) is connected when exercising IP control
over the unit from an external device. Use a LAN cable
or better, STP, maximum 100 m (328 ft)) for connection.
*
1
Use of an STP (shielded twisted pair) cable is recommended.
(category 5e
1
*
Advertisement
Table of Contents
