Changing The Console Serial Port Settings - Avaya 580 User Manual

Chapter 2
CLI Command

Changing the Console Serial Port Settings

2-26
Figure 2-13. Delete User Account Web Page
5. Click YES to delete the user account.
To delete a user account, use the following CLI command:
(configure)# no username <name>
You can change the communications settings for the serial port connection
located on the front panel of the layer 3 supervisor module from the Web
Agent. The switch's console port is initially configured as a TTY Console to
support a TTY connection. The layer 2 and layer 3 supervisor modules
allow you to reconfigure the console serial port as a PPP Console to support
a dial-in PPP connection using a modem.
* Note: If you reconfigure the serial port as a PPP console, you can only
change the switch's baud rate and flow control parameters. The
flow control parameters are limited to None or Xon/Xoff.
This section contains procedures for the following tasks:
Configuring the Serial Console Port as a TTY Console
Configuring the Serial Console Port as a PPP Console
Regaining Configuration Access to the PPP Serial Port Console
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1