Part Iii - Power Connector And Cable Assembly Instructions - Motorola MOTOMESH Duo 4300-49 User Manual

Figure 3-4
NOTE: Be sure to cut the RED WIRE Back as it in not used – the Red Wire is not shown in
the above graphic.
Part III – Power Connector and Cable Assembly
1. Take the yellow plug apart, by separating the plug into three parts: Plug terminal, Body,
Clamp nut (shown from left to right).
Figure 3-5
2. Place the Connector parts over the Power Cable as shown below.
Figure 3-6
3. Attach the cable wires to the terminal plug in the following way:
May 2008
Power Cable Wire Designation
Yellow Plug Separated into Main Parts
Correct Placement of Connector Parts over the Power Cable
3-3
MOTOMESH DUO 2.1 4300 Users Guide
WHITE Wire is Neutral
BLACK Wire is Line
GREEN Wire is Earth Ground
Instructions