Step 3-Set Up And Run An Acquisition Method - Agilent Technologies 1100 series Quick Start Manual

Step 3—Set up and run an acquisition method
Before you do this step, make sure that the instrument has been tuned and
calibrated recently, or that the current calibration is accurate. If not, follow the
instructions in
to tune or calibrate the instrument.
Read and follow the steps on the next pages that take you through the roadmap
below. These steps introduce you to the general procedure but should be used only
as a quick reference. For more detailed instructions refer to the Familiarization
Guide.
Also, refer to the user information listed below to learn how to set up methods.
• Concepts
• Familiarization
• Online Help for the tasks listed in the roadmap below, descriptions of the fields
22
Chapter
Guide—Chapter
the method and data file structure, as well as the recommended strategy for
developing LC/MS methods
Guide—Chapter
learn how to perform the tasks to implement the method development strategy.
in the windows and dialog boxes needed for these tasks and the tasks listed on
the next pages.
Start
1
Enter LC
parameters
Here!
Set up and
run an
acquisition
method
5
Acquire data
1, "Prepare for the analysis" of the Familiarization Guide
3, "How LC/MSD Trap Methods Work" to learn about
2, "Set up and run acquisition methods", to
2
Enter MS
parameters
3
Enter sample
information
4
Set up
displays
Agilent 1100 Series LC/MSD Trap System Quick Start Guide