HP 10500 Series Configuration Manual page 92

Download the file temp.bin from the PC to the device, and upload the configuration file startup.cfg
•
from the device to the PC for backup.
Figure 31 Network diagram
Configuration procedure
# Configure IP addresses as shown in
(Details not shown.)
# Examine the storage space of the device. If the free space is insufficient, use the delete/unreserved
file-url command to delete unused files. (Details not shown.)
# Log in to the FTP server at 10.1.1.1 using the username abc and password 123456.
<Sysname> ftp 10.1.1.1
Press CTRL+C to abort.
Connected to 10.1.1.1 (10.1.1.1).
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User (10.1.1.1:(none)): abc
331 Give me your password, please
Password:
230 Logged in successfully
Remote system type is MSDOS.
200 Type is Image (Binary)
ftp>
# Download the file temp.bin from the PC to the Flash root directory of the active MPU.
ftp> get temp.bin
local: temp.bin remote: temp.bin
150 Connecting to port 47457
226 File successfully transferred
23951480 bytes received in 95.399 seconds (251.0 kbyte/s)
# Download the file temp.bin from the PC to the Flash root directory of the standby MPU (in slot 1).
ftp> get temp.bin slot1#flash:/temp.bin
# Set the file transfer mode to ASCII and upload the configuration file startup.cfg from the device to the
PC for backup.
ftp> ascii
200 TYPE is now ASCII
ftp> put startup.cfg back-startup.cfg
local: startup.cfg remote: back-startup.cfg
150 Connecting to port 47461
226 File successfully transferred
3494 bytes sent in 5.646 seconds (618.00 kbyte/s)
ftp> bye
221-Goodbye. You uploaded 2 and downloaded 2 kbytes.
Figure 31 and make sure the device and PC can reach each other.
84