HP 10500 Series Configuration Manual page 199

Figure 50 Network diagram
Device
MDC A
Server
Department A
Configuration procedure
1. Create and configure MDCA for Department A:
# Create MDCA.
<Device> system-view
[Device] mdc MDCA
Executing this command will create MDC MDCA ID 2 and empty folder /mdc/mdc2 in the
root directory of the storage media. Continue? [Y/N]:y
This MDC was created successfully
# Reclaim the interface card in slot 2 from the default MDC and assign it to MDCA.
[Device-mdc-2-MDCA] mdc Admin
[Device-mdc-1-Admin] undo location slot 2
The configuration associated with the specified slot of MDC will be lost. Continue?
[Y/N]:y
[Device-mdc-1-Admin] mdc MDCA
[Device-mdc-2-MDCA] location slot 2
# Assign interfaces Ten-GigabitEthernet 2/0/1 through Ten-GigabitEthernet 2/0/48 to MDCA.
[Device-mdc-2-MDCA] allocate interface ten-gigabitethernet 2/0/1 to
ten-gigabitethernet 2/0/48
The configurations of the interfaces will be lost. Continue? [Y/N]:y
# Configure MDCA to use up to 40 percent of the total disk space on the MPUs in slot 0 and slot
1.
[Device-mdc-2-MDCA] limit-resource disk slot 0 ratio 40
[Device-mdc-2-MDCA] limit-resource disk slot 1 ratio 40
# Start MDCA.
Internet
Switch A
MDC B MDC C
Server Server
Department B Department C
191