HP 10500 Series Configuration Manual page 38

Step
3. Enter VTY line view or
class view.
4. Enable scheme
authentication.
To use scheme authentication, you must also configure login authentication methods in ISP domain view.
For more information, see Security Configuration Guide.
The next time you attempt to Telnet to the CLI, you must provide the configured login username and
password, as shown in
attempt fails and the message "All lines are used, please try later!" appears.
Command
•
To enter VTY line view:
line vty first-number
[ last-number ]
•
To enter VTY line class
view:
line class vty
authentication-mode scheme
Figure 1 1. If the maximum number of login users has been reached, your login
30
Remarks
Use either command.
A setting in user line view is applied only to
the user line. A setting in user line class
view is applied to all user lines of the class.
A non-default setting in either view takes
precedence over a default setting in the
other view. A non-default setting in user
line view takes precedence over a
non-default setting in user line class view.
A setting in user line view takes effect
immediately and affects the online user. A
setting in user line class view does not
affect online users and takes effect only for
users who log in after the configuration is
completed.
By default, password authentication is
enabled for VTY lines.
In VTY line view, this command is
associated with the protocol inbound
command:
•
If the setting of either command is not
the default in VTY line view, the setting
of the other command in VTY line view
takes effect.
•
If the settings of both commands are the
defaults in VTY line view, the settings of
the commands in VTY line class view
take effect.