Table of Contents
Advertisement
Page 40 - Initial Assembly
Voice Compression Module (VCM)
An optional Voice Compression Module (see pages 14, 18 and 22) is fitted to an IP Office base unit
as follows:
Procedure
1. Remove the three fixing screws on the rear of cover.
2. Turn the unit over and remove the four fixing screws from the base.
3. Slide the cover from the unit.
4. Mount the VCM in position as shown below and secure with the two snap-in spacers.
5. Replace cover and secure with the seven fixing screws.
Caution:
Page 40 - Installing a New System
Initial Assembly
While installing, ensure that you wear a ground wrist strap that is connected
to a suitable grounding point.
Installing a New System
IP Office Installation Manual
40DHB0002USCL – Issue 7 (09/25/2002)
Advertisement
Table of Contents
