Wall Mounting 2000 Series Telephones - Avaya IP OFFICE 40DHB0002USCL Installation Manual

Avaya ip phone user manual
Table of Contents

Advertisement

Page 48 - Wall Mounting 2000 Series Telephones

Wall Mounting 2000 Series Telephones

Mounting brackets exist which clip onto the base on IP Office telephones. These brackets (two
required per telephone) can be used to either raise the desk position of the telephone or for wall
mounting. Before wall mounting a telephone, check that the surface is flat, vertical and not subject to
movement or vibration.
To wall mount an IP Office telephone :
1. Using the dimensions given below, mark the position for the screw holes. Ensure that adequate
clearance above and below the telephone is allowed.
2. Drill the necessary holes and insert the wall plugs.
3. Insert the screws, leaving the heads approximately 3mm proud of the surface (check by clipping a
bracket over the screw head).
4. Attach the brackets to the telephone. Then slide the bracket key-slots over the screw-heads.
5. Reverse the position of the handset retainer tab (located below the hook switch on the telephone).
This keeps the handset in place whilst the telephone is mounted on the wall.
Additional Items :
– Two No. 8 Pan head or
– Two wall plugs.
– Drill and drill bit.
– Screwdriver.
Page 48 - Telephone Installation
Wall Mounting 2000 Series Telephones
Round head screws.
IP Office 2030/50 Telephones
(Not to scale)
Telephone Installation
IP Office 2010 , IP Office 20AT
Telephones (Not to scale)
IP Office Installation Manual
40DHB0002USCL – Issue 7 (09/25/2002)

Advertisement

Table of Contents
loading

Table of Contents