Yamaha SR400 2014 Service Manual page 61

1. Rear brake light switch
2. Rear brake light switch lead
3. Throttle position sensor coupler
4. Fuel sender lead
5. Fuel tank
6. Oil hose 2
7. O sensor coupler
2
8. Right handlebar switch lead
9. Front brake light switch lead
10. Throttle cable
11. Brake hose
12. Tachometer cable
13. Decompression cable
14. O sensor
2
15. Air induction system solenoid coupler
16. Frame
17. Horn lead
18. Horn
A. Fasten the rear brake light switch lead with the
plastic locking tie. Direct the end toward the rear
inner side of the vehicle.
B. Pass the rear brake light switch lead through the
inside of the frame.
C. Pass the tube through a plastic locking tie and fas-
ten the oil hose 2. Direct the end toward the inside
of the vehicle.
D. Fasten the oil hose 2 and fuel sender lead with the
clamp.
E. Point the end of the clamp toward the outside of
the vehicle.
F. To the fuel tank
G. Route the throttle cable above the wire harness.
H. Route the wire harness to the right side of the
head pipe.
I. Route the brake hose to the inside of the front fork.
J. Fasten the brake hose with the clamp.
K. Route the O sensor lead outside of the fuel tank
2
breather hose and above the tank stopper. Route
the O sensor lead inside of the tachometer cable
2
and decompression cable.
L. Turn back the air induction system solenoid lead at
the boot end of the coupler.
M. Fasten the oil hose 2 and air induction system
solenoid lead with the clamp. Point the open end
toward the inside of the vehicle.
N. Horn lead routing
O. Install the horn connector to the horn to point
downward.
P. Install the holder so that its projection is hooked on
the inside of the lower bracket.
2-34
CABLE ROUTING