Removing The Fuel Pump Case - Yamaha SR400 2014 Service Manual

i. Remove the clamp "1" and disconnect the
fuel sender coupler "2".
2
j. Remove the fuel tank bolt "1".
1
k. Disconnect the fuel hose (pressure regula-
tor–fuel tank) "1" at the fuel tank side.
1
l. Remove the fuel tank.
TIP
Be sure to place the fuel tank horizontally. Place
the fuel tank so that it does not to come into di-
rect contact with the fuel cock.
1
1
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS2RD1034

REMOVING THE FUEL PUMP CASE

EWA2RD1010
WARNING
Gasoline is very flammable and dangerous.
While handling gasoline, keep it away from
an open flame as well as a spark or any other
source of high heat.
TIP
Before removing the fuel hose, blow away any
dirt accumulated around the hose with com-
pressed air to prevent it from entering the hose
or tank.
1. Remove:
• Side cover (left)
Refer to "GENERAL CHASSIS" on page 4-1.
2. Remove:
• Fuel pump case
EWA2RD1009
WARNING
Cover fuel hose connection with a cloth
when disconnecting them. Residual pres-
sure in the fuel lines could cause fuel to
spurt out when removing the hose.
ECA2RD1010
NOTICE
Be sure to disconnect the fuel hose by hand.
Do not forcefully disconnect the hose with
tools.
TIP
• Before removing the hose, place a few rags in
the area under where it will be removed.
• Wipe off any spilled fuel immediately.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Turn the fuel cock to the "OFF" position "a".
a
b. Turn the main switch to "ON" and 3 seconds
later turn it to "OFF". Repeat these steps four
times.
6-5
FUEL TANK