Yamaha SR400 2014 Service Manual page 208

4. Lubricate:
• Friction plate
• Clutch plate
(with the recommended lubricant)
Recommended lubricant
Engine oil
5. Install:
• Friction plate
• Clutch plate
TIP
First, install a friction plate and then alternate be-
tween a clutch plate and a friction plate.
6. Install:
• Bearing
• Oil seal
New
• Washer
• Torsion spring "1"
• Push lever shaft "2"
• Adjuster "3"
• Gasket
New
• Locknut "4"
Adjuster locknut
18 Nm (1.8 m·kgf, 13 ft·lbf)
• Clutch cable
4
3
7. Install:
• Clutch push rod 2
• Pressure plate "1"
• Clutch spring
• Clutch spring bolt
Clutch spring bolt
9 Nm (0.9 m·kgf, 6.5 ft·lbf)
TIP
• Align the match mark "a" in the pressure plate
with the match mark "b" in the clutch boss be-
fore installation.
• Tighten the clutch spring bolts in stages and in
a crisscross pattern.
2
1
5-34
a
8. Check:
• Push lever position
The push lever "1" and the match mark "a" in
the crankcase are not aligned with each other
as shown in the illustration  Correct.
TIP
Push the push lever in the arrow direction and
make sure the marks are aligned.
a
1
9. Adjust:
• Push lever position
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen the locknut "1".
b. Turn the adjuster "2" in or out until the marks
are aligned.
c. Hold the adjuster to prevent it from moving
and then tighten the locknut to specification.
ECA13820
NOTICE
Do not overtighten the locknut since this will
remove the free play between both push
rods.
Adjuster locknut
18 Nm (1.8 m·kgf, 13 ft·lbf)
CLUTCH
b
1