Port Link-Type - HP A5830 Series Command Reference Manual

<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done.
Configuring GigabitEthernet1/0/1... Done.
Configuring GigabitEthernet1/0/2... Done.
Configuring GigabitEthernet1/0/3... Done.
The output shows that Gigab.itEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 are
the member ports of the aggregation group corresponding to Bridge-Aggregation 1.

port link-type

Description
Use the port link-type command to configure the link type of a port.
Use the undo port link-type command to restore the default link type of a port.
By default, any port is an access port.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports:
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access.
After you change the link type of an interface with the port link-type command, the loopback detection
action configured on the interface with the loopback-detection action command automatically restores the
default. For more information about the loopback detection action configuration, see Layer 2—LAN
Switching Configuration Guide.
Syntax
port link-type { access | hybrid | trunk }
undo port link-type
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
access: Configures the link type of a port as access.
hybrid: Configures the link type of a port as hybrid.
160