Configure Rs 232 - Fluke NORMA 4000 Operator's Manual

Configure Interface to PC
Settings
RS232
GPIB
LAN
SCPI
D5255S
D5255T
D5255M
1. Move the cursor to the field with the value you wish to change, enter the new
value and confirm by pressing Enter.
2. Select the settings and confirm by pressing Enter.
The applied settings are shown in line Syst IF.
A CD to install USB driver support to the PC is included in the delivery
content. The USB interface is installed as a virtual COM port.

Configure RS 232

Settings
115200 ...1200
8/N/1 ...7/O/1
none
HW
XON
The factory settings of the RS232 interface are optimized for
communication with a PC. We recommend adjusting the settings of the PC
to suit these parameters.
Factory configuration: 115200 8/N/1 HW
1. On the connected PC, call up the Device Manager and open the dialog showing
the settings for the serial port.
2. Adjust these settings to those of the Power Analyzer.
Shop for Fluke products online at:
Serial interface
General Purpose Interface Bus: IEEE488 interface (optional)
Ethernet (LAN) interface (optional)
Standard set of commands
Previous set of commands (emulation)
Previous set of commands (emulation)
Previous set of commands (emulation)
Note
Baud rate of serial interface
Data bits/parity/stop bits of the serial interface
Handshake (protocol) of the serial interface
Note
MyFlukeStore
www.
Configure Data Transfer to Printer and PC
Description
Description
1.888.610.7664
.com
7
Configuration
7-7