Measurement With Voltage And Current Transducer - Fluke NORMA 4000 Operator's Manual

In Figures 5-3, 5-6, and 5-9, Fluke recommends using MCS measuring
leads for triaxial shunts and MCP leads for planar shunts. Triaxial shunts
are equipped with guard connectors in the plugs and planar shunts are
equipped with guard sockets.

Measurement with Voltage and Current Transducer

Figure 5-4 shows the connections for measurements with a voltage and current
transducer.
To prevent damage to the transducer due to overload, check
transducer rating.
Transducer errors limit the measuring bandwidth and reduce the intrinsic
uncertainty.
To avoid possible electric shock or personal injury:
•
Risk of injury when touching connections, internal circuits,
and measuring devices that are not connected to earth
ground.
•
Always adhere to the instructions regarding the sequence of
connection (see Chapter 5, "Connecting Sequence").
L1
N
Shop for Fluke products online at:
Note
W Caution
Note
XW Warning
P P
2 1
S
2
S
1
N
n
HI HI
VOLTAGE VOLTAGE
1000 V max 1000 V max
LO LO
3 2
PROBE PROBE
EXT.SHUNT EXT.SHUNT
10 V max 10 V max
HI HI
CURRENT CURRENT
10 A max 10 A max
LO LO
ALL INPUTS MAX 1000V CATII TO
Figure 5-4. Voltage and Current Transducer Measurement
MyFlukeStore
www.
A
a
Max. 10 m
V
1
.com
Connection to Circuits
1-Phase Measurement
Load
esn011.eps
1.888.610.7664
5
5-7