Configuring An Ipv6 Basic Acl - HP 5830 Series Configuration Manual

Acl and qos
Hide thumbs Also See for 5830 Series:
Table of Contents

Advertisement

Step
1.
Enter system
view.
2.
Create an IPv4
basic ACL and
enter its view.
3.
Configure a
description for
the IPv4 basic
ACL.
4.
Set the rule
numbering
step.
5.
Create or edit a
rule.
6.
Add or edit a
rule comment.
7.
Add or edit a
rule range
remark.
8.
Enable
counting ACL
rule matches
performed in
hardware.

Configuring an IPv6 basic ACL

IPv6 basic ACLs match packets based only on source IP addresses.
To configure an IPv6 basic ACL:
Step
1.
Enter system view.
2.
Create an IPv6
basic ACL view
and enter its view.
Command
system-view
acl number acl-number
[ name acl-name ]
[ match-order { auto |
config } ]
description text
step step-value
rule [ rule-id ] { deny |
permit } [ counting | fragment
| logging | source
{ source-address
source-wildcard | any } |
time-range time-range-name
| vpn-instance
vpn-instance-name ] *
rule rule-id comment text
rule [ rule-id ] remark text
hardware-count enable
Command
system-view
acl ipv6 number acl6-number
[ name acl6-name ]
[ match-order { auto | config } ]
Remarks
N/A
By default, no ACL exists.
IPv4 basic ACLs are numbered in the range of 2000 to
2999.
You can use the acl name acl-name command to enter
the view of a named ACL.
Optional.
By default, an IPv4 basic ACL has no ACL description.
Optional.
The default setting is 5.
By default, an IPv4 basic ACL does not contain any
rules.
If the ACL is for QoS traffic classification, do not
specify the vpn-instance keyword. Also, the logging
and counting keywords (even if specified) do not
take effect.
If the ACL is for packet filtering, do not specify the
vpn-instance keyword.
Optional.
By default, no rule comments are configured.
Optional.
By default, no rule range remarks are configured.
Optional.
By default, this feature is disabled.
When the ACL is referenced by a QoS policy, this
command does not take effect.
Remarks
N/A
By default, no ACL exists.
IPv6 basic ACLs are numbered in the range of
2000 to 2999.
You can use the acl ipv6 name acl6-name
command to enter the view of a named ACL.
5

Advertisement

Table of Contents
loading

Table of Contents