Configuring The Rate Limit; Displaying And Maintaining Traffic Policing, Gts, And Rate Limit; Traffic Policing And Gts Configuration Example; Network Requirements - HP 5830 Series Configuration Manual

Configuring GTS for all traffic
Step
1. Enter system view.
2. Enter interface view.
3. Configure GTS on the
interface.

Configuring the rate limit

The rate limit of a physical interface specifies the maximum rate of incoming packets or outgoing packets.
To configure the rate limit:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the rate limit
for the interface.
Displaying and maintaining traffic policing, GTS,
and rate limit
On the device, you can configure traffic policing by using the MQC approach. For more information
about the displaying and maintaining commands, see
Task
Display interface GTS
configuration information.
Display interface rate limit
configuration information.

Traffic policing and GTS configuration example

Network requirements

As shown in
GigabitEthernet 1/0/3 of Device A is connected to GigabitEthernet1/0/1 of Device B.
•
• Server, Host A, and Host B can access the Internet through Device A and Device B.
Command
system-view
interface interface-type interface-number
qos gts any cir
committed-information-rate
Command
system-view
interface interface-type interface-number
qos lr { inbound | outbound } cir
committed-information-rate [ cbs
committed-burst-size ]
Figure 12:
"QoS configuration
Command
display qos gts interface [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
display qos lr interface [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
35
Remarks
N/A
N/A
N/A
Remarks
N/A
N/A
N/A
approaches."
Remarks
Available in any
view.
Available in any
view.