Displaying And Maintaining Class-Based Traffic Accounting; Configuration Example - HP 5830 Series Configuration Manual

Displaying and maintaining class-based traffic
accounting
To verify the class-based accounting configuration, use the display qos policy global, display qos policy
interface, or display qos vlan-policy command in any view to display the traffic statistics collected after
the configuration is complete.

Configuration example

Network requirements
As shown in
1.1.1.1/24 and received on GigabitEthernet 1/0/1.
Figure 20 Network diagram
Configuration procedure
# Create basic ACL 2000 and configure a rule to match packets with source IP address 1.1.1.1.
<DeviceA> system-view
[DeviceA] acl number 2000
[DeviceA-acl-basic-2000] rule permit source 1.1.1.1 0
[DeviceA-acl-basic-2000] quit
# Create a class named classifier_1 and use ACL 2000 as the match criterion in the class.
[DeviceA] traffic classifier classifier_1
[DeviceA-classifier-classifier_1] if-match acl 2000
[DeviceA-classifier-classifier_1] quit
# Create a behavior named behavior_1 and configure the traffic accounting action that counts traffic in
packets.
[DeviceA] traffic behavior behavior_1
[DeviceA-behavior-behavior_1] accounting packet
[DeviceA-behavior-behavior_1] quit
# Create a policy named policy, and associate class classifier_1 with behavior behavior_1 in the policy.
[DeviceA] qos policy policy
[DeviceA-qospolicy-policy] classifier classifier_1 behavior behavior_1
[DeviceA-qospolicy-policy] quit
# Apply the policy named policy to the incoming traffic of GigabitEthernet 1/0/1.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] qos apply policy policy inbound
[DeviceA-GigabitEthernet1/0/1] quit
# Display traffic statistics to verify the configuration.
[DeviceA] display qos policy interface gigabitethernet 1/0/1
Figure 20, configure class-based accounting to collect the number of packets sourced from
61