Chapter 8 Batch Files
Creating and running batch files
Creating and running batch files
Available commands for batch files
80
This section describes how to create and run batch files.
To create a batch file
1 Run the UNIX vi editor, and edit a new file.
2 Type commands as you would at a command prompt.
3 Save the file.
To run a batch file
1 Type the command Batch_Command <file_name>, where
file_name is the name of the file containing CT-650 commands.
To interrupt a batch file that is in progress, press Ctrl+c .
Table 5
lists which CT-650 commands you can use in batch files.
Remember to end the last line of a batch file by pressing Enter before
saving and exiting.
Table 5
Allowed commands for batch files
! (History)
Abort
Alarm_Check
Batch_Command
Clear_Alarm
Daytime
DCS_Direct
DDS
DDS_Measure
DDS_Split
Disconnect
CT-650 Command-Line Reference Guide
FEAC_Alarm
FT1
Help
Information
Inject_Errors
Line_Coding
List_Files
Log_Errors
Logout
Loopback
Main_Exit
Release 9.4
TAP_Loopback
Tx_X_Bit
UF_Split
User_Pattern
Version
VF
VF_Measure
VF_Split
Who
Yellow_Alarm