About The Automated Tests; Running The Onecheck Test - JDS Uniphase SmartClass User Manual

Triple play services tester
Hide thumbs Also See for SmartClass:
Table of Contents

Advertisement

Chapter 3 Automated Testing

About the automated tests

About the automated tests
The SmartClass Triple Play Services includes two automated tests:
OneCheck —
connectivity and upstream/downstream thresholds, a ping test to verify data layer connectivity, a
FTP or HTTP test to verify data upload and download rates, a video test (as described in the video
check below), and a VoIP test. Then the test reports pass/fail results.
VideoCheck —
included as a part of the OneCheck test, but can be run as a separate test when only the Video
layer needs to be verified.

Running the OneCheck test

The OneCheck test is an automated sequence of tests. The test runs a DSL, Ethernet, or WiFi test
to test connectivity and upstream/downstream thresholds, a ping test to verify connectivity, a FTP
test to verify upload and download rates, a video test to verify the channels are provisioned as the
subscriber requested, and a VoIP test to verify call placement and QoS thresholds.
To run the OneCheck test
1
Launch the desired application: DSL, Ethernet, or WiFi.
2
Select OneCheck.
The OneCheck menu appears. From this menu, you can start the test sequence or go to the
setup menus for each test.
3
To select which tests to run, either highlight the test and then press OK, or press the number
for that test to toggle enabled or disabled.
The only exception is VoIP. Select VoIP and then specify how the OneCheck script will place
the VoIP call:
– Automatic – automatically place a call
– Manual – display the VoIP call screen and wait for you to initiate the call manually
– Disable – don't run the VoIP test
To specify the test settings, press the  key, and then select which test to setup.
4
a
NOTE:
DSL Setup is only available if testing over DSL. If testing over Ethernet or WiFi, this selection will
not appear.
32
Allows triple play testing by running a DSL, Ethernet, or WiFi test to verify network
Verifies whether all channels are available as ordered by the subscriber. The test is
Select DSL Setup, and then specify the following:
SmartClass TPS User's Guide
22035456, Rev 001
June 2014

Advertisement

Table of Contents
loading

Table of Contents