Finishing; Door & Screen Operation - Napoleon NZ7000 Installation And Operating Instructions Manual

6.0 FINISHING

USE ONLY A NON-COMBUSTIBLE MATERIAL TO FINISH THE FACE OF THE APPLIANCE.
A NON-COMBUSTIBLE MATERIAL SUCH AS CEMENT BOARD IS REQUIRED FOR THIS PURPOSE.
VENTILATION OPENINGS ARE RECOMMENDED FOR ALL ENCLOSURES.
ABOVE 8' (2.4M) COMBUSTIBLE FINISHING MATERIALS MAY BE USED ON THE FRONT FACE.
6.1 DOOR & SCREEN OPERATION
NOTE: The appliance should be operated with either the glass or screen door closed, other than when
loading wood.
Insert tether into screen and glass door receiver bottom left corner to raise and lower the door. When not in
use, hang tether on tool set.
To swing open the glass door, lift the latch on the right side up and swing the door outward.
TETHER
DO NOT INSULATE AROUND THE APPLIANCE.
NOTE: To prevent the rapid rise of the
doors, since they are balanced with
balance weights, it is recommended
to secure the cable on the top of the
door frame when removing the door
or screen frames for servce
25
EN
W415-1676 / B / 10.26.17