PARTS
WASH MOTORS: Overloads are specified for 3-phase units only.
For GE brand MT03* series overloads, the process for setting is as follows:
•
Determine the Full Load Amps (FLA) for the wash motor.
•
Set the overload at the closest setting without going over for the FLA of the motor.
The overload already compensates for the FLA and will have a setpoint that is 125% of the FLA. (Example: Wash motor
•
is rated at 10.0 FLA on the data plate. The replacement MT03* overload will be set at 10.0. It will trip at 12.5 Amps.)
WASH MOTOR
VOLTAGE
208
230
DRIVE MOTORS: Overloads are specified for 3-phase units only.
For GE brand MT03* series overloads, the process for setting is as follows:
•
Determine the FLA for the drive motor.
•
Set the overload at the closest setting without going over for the FLA of the motor.
The overload already compensates for the FLA and will have a setpoint that is 125% of the FLA. (Example: Drive motor
•
is rated at 1.0 FLA on the data plate. The replacement MT03* overload will be set at 1.0. It will trip at 1.25 Amps.)
DRIVE MOTOR
VOLTAGE
208
230
PRE-WASH MOTORS: Overloads are specified for 3-phase units only.
For GE brand MT03* series overloads, the process for setting is as follows:
•
Determine the FLA for the pre-wash motor.
•
Set the overload at the closest setting without going over for the FLA of the motor.
The overload already compensates for the FLA and will have a setpoint that is 125% of the FLA. (Example: Pre-wash
•
motor is rated at 6.0 FLA on the data plate. The replacement MT03* overload will be set at 6.0. It will trip at 7.5 Amps.)
PRE-WASH MOTOR
VOLTAGE
208
230
460
NOTE: Connections should be tightened to 7 in-lbs.
53
PART NUMBER
05945-111-68-40
05945-111-68-40
PART NUMBER
05945-111-68-39
05945-111-68-39
PART NUMBER
05945-003-76-28
05945-003-76-28
05945-003-76-26
MOTOR OVERLOADS
GE PART NUMBER
RT1M
RT1M
GE PART NUMBER
RT1G
RT1G
GE PART NUMBER
MT03M
MT03M
MT03K
Blue selector switch should be
set to H for manual reset.
Blue selector switch should be
set to H for manual reset.
Blue selector switch should be
set to H for manual reset.
07610-004-33-05-B