Table of Contents
Advertisement
Figure -
Assembling the Mounting Screws and Spring Washers to the OmniAccess AP
•
Copy the MAC address(es) from the label(s) on the OmniAccess AP onto the corresponding
location on the map. MAC addresses have the format 000B85xxxxxx.
•
You have already attached the flush-mount bracket to the wall in
Locations.
•
Slide the screws into the keyhole slots on the mounting bracket as shown in the following
figure.
Note:
Make sure the side of the OmniAccess AP with the door is facing away from the wall.
This ensures that the correct antenna is facing the building, and makes future upgrades
easier.
Note:
If the screws do not securely hold the bracket, remove the OmniAccess AP and adjust
the screws until they securely hold the bracket.
3/16/04
90-100832-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 21
Step 4: Mounting the OmniAccess APs
Step 3: Preparing Mounting
Advertisement
Table of Contents
