Table of Contents
Advertisement
Figure -
Assembling the OmniAccess AP and Ceiling-Mount Base
•
Copy the MAC address(es) from the label(s) on the OmniAccess AP onto the corresponding
location on the map. MAC addresses have the format 000B85xxxxxx.
•
Attach the ceiling-mount base to the bottom of the OmniAccess AP using the factory-supplied
machine screws and washers.
•
Position the ceiling-mount base so its keyhole slots are partly on the drywall, sheet metal, or
other screw heads installed in
If the screws do not securely hold the ceiling-mount base, remove the OmniAccess AP
Note:
and adjust the screws until they hold the ceiling-mount base securely.
•
Attach the cables to the sides of the OmniAccess AP.
Note:
When the OmniAccess AP is powered up and is associated with an Alcatel OmniAccess
Wireless Switch or Appliance (Green/Power and Yellow/802.11b/g and/or Yellow or Amber/
802.11a LEDs lit), the OmniAccess AP is broadcasting its beacon signal(s). When this
happens, complete the installation as quickly as possible to remove yourself from within
8 inches (20 cm) of the OmniAccess AP to comply with FCC RF radiation exposure guidelines.
•
Slide the ceiling-mount base onto the drywall, sheet metal, or other screw heads until it snugs
into place.
3/16/04
90-100832-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 16
Step 3: Preparing Mounting
Step 4: Mounting the OmniAccess APs
Locations.
Advertisement
Table of Contents
