Table of Contents
Advertisement
Figure -
Assembling the OmniAccess AP to the Flush-Mount Bracket
•
Attach the cables to the sides of the OmniAccess AP.
Note:
Make sure the cables are routed away from the OmniAccess AP antennas.
Note:
When the OmniAccess AP is powered up and is associated with an Alcatel OmniAccess
Wireless Switch or Appliance (Green/Power and Yellow/802.11b/g and/or Yellow or Amber/
802.11a LEDs lit), the OmniAccess AP begins broadcasting its beacon signal(s). When this
happens, complete the installation as quickly as possible to remove yourself from within
8 inches (20 cm) of the OmniAccess AP to comply with FCC RF radiation exposure guidelines.
You have installed the OmniAccess AP. Repeat
Access AP location, and then continue with
3/16/04
90-100832-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 22
Step 4: Mounting the OmniAccess APs
Step 5: Returning MAC
Step 4: Mounting the OmniAccess APs
for each Omni-
Information.
Advertisement
Table of Contents
