Table of Contents
Advertisement
•
When you are mounting the OmniAccess AP against a wall (flat Side A toward the inside of the
building), use the flush-mount bracket supplied with the OmniAccess AP. The flush-mount
L-bracket is the one with one long and one short leg. Use the L-bracket to mark the sheet
metal, drywall, or other screw locations.
About Physical Security
Regardless of mounting, the OmniAccess AP can be secured with a Kensington MicroSaver Security
Cable. If required, use any MicroSaver Security Cable to attach either side of your OmniAccess AP to a
solid beam, pipe, or support.
FCC Statements for OmniAccess APs
This section includes the following FCC statements for the OmniAccess AP:
•
Class A Statement
•
RF Radiation Hazard Warning
•
Non-Modification Statement
•
Deployment Statement
Class A Statement
Class A Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
RF Radiation Hazard Warning
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location
such that the antenna of the device will be greater than 20 cm (8 in.) from all persons. Using higher
gain antennas and types of antennas not covered under the FCC certification of this product is not
allowed.
Installers of the radio and end users of the Alcatel OmniAccess Wireless Enterprise Platform must
adhere to the installation instructions provided in this manual.
Non-Modification Statement
Use only the supplied internal antenna, or external antennas supplied by the manufacturer. Unautho-
rized antennas, modifications, or attachments could damage the badge and could violate FCC
regulations and void the user's authority to operate the equipment.
Deployment Statement
This product is certified for indoor deployment only. Do not install or use this product outdoors.
3/16/04
90-100832-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 26
About Physical Security
RF Radiation Hazard Warning
Non-Modification Statement
Deployment Statement
FCC Statements for OmniAccess APs
FCC Statements for OmniAccess APs
Advertisement
Table of Contents
