Table of Contents
Advertisement
Figure -
OmniAccess AP External Antenna Port Markings
About Mounting Options
Note:
Because the OmniAccess AP internal antennas have been designed to reduce inter-floor
interference, it is strongly recommended that you mount the OmniAccess AP standing or
hanging straight up or down.
Note:
You can mount the OmniAccess APs below the ceiling using the ceiling mount base or
wall mount brackets, but the OmniAccess APs perform best when mounted below the ceiling.
•
When you are mounting the OmniAccess AP in the middle of a ceiling, or hallway, you will
typically use the color-coordinated ceiling-mount base to stabilize the OmniAccess AP after it is
mounted. Use the mounting base to mark the sheet metal, drywall, or other screw locations.
The mounting base attaches to the bottom of the OmniAccess AP with two supplied screws, and
then the assembly slides and locks onto two sheet metal, drywall, or other screws.
•
When you are mounting the OmniAccess AP out from a wall (flat sides along the room or
hallway), use the projection-mount L-bracket supplied with the OmniAccess AP. Use the
L-bracket to mark the sheet metal, drywall, or other screw locations.
3/16/04
90-100832-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 25
About Mounting Options
Planning Notes
Advertisement
Table of Contents
