Table of Contents
Advertisement
Figure -
Clipping the OmniAccess AP and Ceiling-Mount Clips to a Hanging-Ceiling Rail
•
Attach the cables to the sides of the OmniAccess AP.
Note:
Make sure the cables are routed away from the OmniAccess AP antennas.
Note:
When the OmniAccess AP is powered up and is associated with an Alcatel OmniAccess
Wireless Switch or Appliance (Green/Power and Yellow/802.11b/g and/or Yellow or Amber/
802.11a LEDs lit), the OmniAccess AP is broadcasting its beacon signal(s). When this
happens, complete the installation as quickly as possible to remove yourself from within
8 inches (20 cm) of the OmniAccess AP to comply with FCC RF radiation exposure guidelines.
You have installed the OmniAccess AP. Repeat
Access AP location, and then continue with
Projection Wall Mount
When you are mounting the OmniAccess AP out from a wall (flat sides along the wall or hallway), use
an optional separately-orderable factory-orderable projection-mount L-bracket.
•
Before proceeding, gently screw the two factory-supplied screws and spring washers into the
bottom of the OmniAccess AP. Make sure the spring washers have their convex (high center
sections) pointing toward the screw heads.
Note:
The OmniAccess AP threaded holes have precision-depth threads. Do not overtighten
the screws, or the bracket will not fit under the screw heads.
3/16/04
90-100832-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 18
Step 4: Mounting the OmniAccess APs
Step 5: Returning MAC
Projection Wall Mount
Step 4: Mounting the OmniAccess APs
for each Omni-
Information.
Advertisement
Table of Contents
