Figure -
Assembling the Mounting Screws and Spring Washers to the OmniAccess AP
•
Copy the MAC address(es) from the label(s) on the OmniAccess AP onto the corresponding
location on the map. MAC addresses have the format 000B85xxxxxx.
•
You have already attached the projection-mount L-bracket to the wall in
Mounting
Locations.
•
Slide the screws into the keyhole slots on the mounting bracket as shown in the following
figure.
Note:
If the screws do not securely hold the bracket, remove the OmniAccess AP and adjust
the screws until they securely hold the bracket.
3/16/04
90-100832-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 19
Step 4: Mounting the OmniAccess APs
Step 3: Preparing