Default Settings For Ntp; Configuring Ntp; Enabling Or Disabling Ntp In A Vdc - Cisco Nexus 7000 Series Configuration Manual

Default Settings for NTP

Default Settings for NTP
The following table lists the default settings for NTP parameters.
Parameters
NTP
NTP passive (enabling NTP to form associations)
NTP authentication
NTP access
NTP access group match all
NTP broadcast server
NTP multicast server
NTP multicast client
NTP logging

Configuring NTP

Be aware that the Cisco NX-OS commands for this feature may differ from those commands used in Cisco
Note
IOS.

Enabling or Disabling NTP in a VDC

You can enable or disable NTP in a particular VDC. NTP is enabled in all VDCs by default.
Procedure
Step 1
Step 2
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
50
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
[no] feature ntp
Example:
switch(config)# feature ntp
Default
Enabled in all VDCs and for all interfaces. By default,
NTP is enabled as server and client.
Enabled
Disabled
Enabled
Disabled
Disabled
Disabled
Disabled
Disabled
Purpose
Enters global configuration mode.
Enables or disables NTP.
Configuring NTP