Adding Show Commands To An Alert Group - Cisco Nexus 7000 Series Configuration Manual

Adding Show Commands to an Alert Group

Step 4
Step 5
Step 6
What to Do Next
Optionally add show commands to an alert group and then configure the SMTP email server.
Adding Show Commands to an Alert Group
You can assign a maximum of five user-defined CLI show commands to an alert group.
You cannot add user-defined CLI show commands to the CiscoTAC-1 destination profile.
Note
Procedure
Step 1
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
122
Command or Action
alert-group {All | Cisco-TAC | Configuration |
Diagnostic | EEM | Environmental | Inventory |
License | Supervisor-Hardware | Syslog-group-port
| System | Test}
Example:
switch(config-callhome)# destination-profile
Noc101 alert-group All
commit
Example:
switch(config-callhome)# commit
show callhome destination-profile [profile name]
Example:
switch(config-callhome)# show callhome
destination-profile profile Noc101
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
Configuring Smart Call Home
Purpose
to associate all alert groups with the
destination profile.
Commits the Smart Call Home
configuration commands.
(Optional)
Displays information about one or more
destination profiles.
(Optional)
Copies the running configuration to the
startup configuration.
Purpose
Enters global configuration mode.