Cisco Nexus 7000 Series Configuration Manual page 126

Configuring Module and Facility Messages Logging
Step 2
Step 3
Step 4
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
98
Command or Action
[no] logging module [severity-level]
Example:
switch(config)# logging module
3
show logging module
Example:
switch(config)# show logging
module
[no] logging level facility
severity-level
Example:
switch(config)# logging level
aaa 2
Configuring System Message Logging
Purpose
Enables module log messages that have the specified
severity level or higher. Severity levels range from 0 to 7:
• 0 – emergency
• 1 – alert
• 2 – critical
• 3 – error
• 4 – warning
• 5 – notification
• 6 – informational
• 7 – debugging
If the severity level is not specified, the default of 5 is used.
The no option disables module log messages.
(Optional)
Displays the module logging configuration.
Enables logging messages from the specified facility that
have the specified severity level or higher. Severity levels
range from 0 to 7:
• 0 – emergency
• 1 – alert
• 2 – critical
• 3 – error
• 4 – warning
• 5 – notification
• 6 – informational
• 7 – debugging
To apply the same severity level to all facilities, use the all
facility. For defaults, see the show logging level command.
The no option resets the logging severity level for the
specified facility to its default level. If you do not specify
a facility and severity level, the device resets all facilities
to their default levels.